Back

Software and printers.

3 May 2019 (15:45 - 16:30)
Organised by:
Congress Presentation Part of: Special Course 4: 3D printing Technology and Physics EACVI Premium Access EuroCMR 2019

About the speaker

Photo
Doctor Giovanni Biglino

University of Bristol, Bristol (United Kingdom of Great Britain & Northern Ireland)

4 More presentations in this session

Presentation thumbnail
This session is supported by Medviso AB in the form of an educational grant. The scientific programme has not been influenced in any way by its sponsor.
Slides
Presentation thumbnail
Principles of rapid manufacturing.
Doctor G. Biglino (Bristol, GB)
Slides
Presentation thumbnail
Introduction to imaging processing.
Professor S. Schievano (London, GB)
Presentation thumbnail
Discussion of adult and paediatric cases.

Access the full session

Session thumbnail
Special Course 4: 3D printing

The Event

Event poster

EuroCMR 2019

3 May 2019 15:45 CET
You may be interested in
thumbnail
Congress Session
Alert-based remote monitoring: changing the paradigm of CIED follow-up
30 March 2025
thumbnail
Congress Presentation
Software-based automated CT analysis for planning TAVI-Procedures: Systematic validation against expert and novice human interpretation
2 September 2019
thumbnail
Seminar Session
Physics-basic principles and signal encoding
1 October 2026
thumbnail
Congress Presentation
One medical device regulation, many country interpretations: lessons learned from EHRA-PATHS software tool use in a clinical trial
14 April 2026

ESC 365 is supported by

novartis Explore sponsored resources
novo-nordisk Explore sponsored resources

ESC 365 is supported by

novartis Explore sponsored resources
novo-nordisk Explore sponsored resources