Back

Principles of rapid manufacturing.

3 May 2019 (15:46 - 16:30)
Organised by:
Congress Presentation Part of: Special Course 4: 3D printing Technology and Physics EACVI Premium Access EuroCMR 2019

About the speaker

Photo
Doctor Giovanni Biglino

University of Bristol, Bristol (United Kingdom of Great Britain & Northern Ireland)

4 More presentations in this session

Presentation thumbnail
This session is supported by Medviso AB in the form of an educational grant. The scientific programme has not been influenced in any way by its sponsor.
Slides
Presentation thumbnail
Introduction to imaging processing.
Professor S. Schievano (London, GB)
Presentation thumbnail
Software and printers.
Doctor G. Biglino (Bristol, GB)
Presentation thumbnail
Discussion of adult and paediatric cases.

Access the full session

Session thumbnail
Special Course 4: 3D printing

The Event

Event poster

EuroCMR 2019

3 May 2019 15:46 CET
You may be interested in
thumbnail
Congress Session
Sustainability of EP procedures in 2023
16 April 2023
thumbnail
Seminar Session
Physics-basic principles and signal encoding
1 October 2026
thumbnail
Congress Presentation
Total anomalous pulmonary venous return. Two sides of the same coin. Two rare cases prepared for intervention with 3D modeling and 3D printing
9 December 2022
thumbnail
Congress Session
Personalised management of the patient on mechanical circulatory support in the cardiac care unit
1 September 2024

ESC 365 is supported by

novartis Explore sponsored resources
novo-nordisk Explore sponsored resources

ESC 365 is supported by

novartis Explore sponsored resources
novo-nordisk Explore sponsored resources